Epoxy Flooring in Eastwood, LA

Eastwood homes rarely sit empty, and that changes how we think about epoxy flooring in Eastwood. The 2020 census put the homeowner vacancy rate at just 1.0%, with 1,704 housing units and 1,569 households. Owners here tend to stay, so they ask about a floor that will still look right in ten or fifteen years. Our answer is to spend more of the budget on prep and on a heavier system.

Where a long-life floor gets its strength

The parts of a coating job that decide how long it lasts are mostly invisible once it is done: 1. Grinding depth. We grind until we reach clean, hard concrete, including along the walls. 2. Crack and joint work. Stable cracks are filled with a repair material made for the job. Moving joints stay open. 3. Base coat thickness. A thicker, higher-solids base hides small flaws and holds a full flake broadcast. 4. Topcoat choice. A chemical- and wear-resistant clear topcoat is what takes the scuffs, so it is the layer we never skimp on.

A floor built that way costs more on day one. Spread over the years you will own it, it usually costs less than a cheaper floor that needs redoing.

Get a Free Estimate

Shops, sheds and bigger lots

The 2020 census classed 25.6% of Eastwood's residents as rural. Many lots are larger than in Bossier City, and plenty have a detached metal shop, a pole barn with a slab or an extra bay for a boat or tractor. Those floors take dropped tools, hydraulic fluid, mower blades and the occasional engine on a stand. For them we use our shop system: a thick 100% solids base, a broadcast for grip and a topcoat that resists oil and fuel. We can also leave a plain sealed area for welding, where sparks and grinding would scar any decorative finish.

Same place, different name

Wikipedia notes that Eastwood is commonly confused with Haughton, which sits nearby to the southeast. Eastwood is its own census-designated place in Bossier Parish, with Red Chute on its western border and US Routes 80 and 79 running east to west through the middle. Downtown Shreveport is about 11 miles west. If your mailing address says Haughton but the house is on the US 80 side, we cover you either way.

What the estimate looks at

On an Eastwood visit we check each slab you want coated. In the house garage we look for oil, old sealer and cracks. In a shop we look at how the floor was poured, whether there is a vapor barrier under it, where water comes in at the big door and what chemicals get used on it. Then we write up each building on its own line so you can do one now and one later.

Planning around the season

Eastwood shares the region's hot, wet summers. Shop buildings without insulation get very hot by midday, so we start those jobs at first light. In winter, we check that an unheated shop slab is warm enough for the coating to cure before we start.